Filter
Top Products
WARNINGS:
CHOICE OF ELECTRICAL
CONNECTION
There are three possible ways to connect your
cooker. In each case the cooker should be
operated using at least 6mm
2
twin core and
earth PVC insulated multicore cable. Please
choose from the most appropriate after reading
the different methods:-
a) By connecting the cooker to a cooker point
(having a double pole isolating switch with at
least 3mm contact separation in all poles and
neutral) and protected with a fuse or miniature
circuit breaker at your mains fuse box.
b) By connecting the cooker together with a hob
directly to a cooker point(s). Having a double
pole isolating switch with at least 3mm contact
separation in all poles and neutral.
c) If you wish to connect an oven and a hob to a
cooker point you can by connecting the oven
and hob separately to the cooker point. Oven
and hob units should be separately connected
to a control panel. See Fig. 2.
NOTE: It is good practice to:
Fit an Earth Leakage Circuit Breaker to your
house wiring.
Wire your appliance to the latest IEE
regulations.
33
This cooker must be installed by a
qualified electrician/competent person.
Safety may be impaired if installation is
not carried out in accordance with
these instructions.
This cooker must be earthed.
Do not remove the screws from the
earth tab extending from the oven
mains terminal block (Fig.1).
Before connecting the cooker make
sure that the voltage of your electricity
supply is the same as that indicated on
the rating plate. The rating plate can be
seen by opening the oven door and
looking below the oven door seal.
Do not alter the electrical circuitry of
this cooker.
Fig.1
Subject to Regional Electricity Company
regulations if you wish to connect the
oven and hob to the power supply you
may use one of the following two
methods:-
Fig. 2
Red or
Brown
Blue or
Black
5mm
Mains
Cable
Earth Tab
Earth (Green or
Green/Yellow)