Electrolux EFC 630 Ventilation Hood User Manual


 
8
SOMETHING NOT WORKING
If, having followed these instructions carefully, your cooker hood fails to work properly please carry out
the following checks.
Symptom Solution
The cooker hood will not start Check the hood is connected to the
electricity supply.
Make sure the switch is in the ‘ON’ position.
The cooker hood is not working effectively The fan speed is set high enough for
the task
The grease filter is clean.
The kitchen is adequately vented to
allow the entry of fresh air.
If set up for recirculation, check that the
charcoal filter is still effective.
If set up for extraction, check that the
ducting and outlets are not blocked.
The cooker hood has switched off during The safety cut-out device has been tripped.
operation Tum off the hob and then wait for the device
to reset.
If after all these checks, the fault persists,
contact your local Service Force Centre,
quoting the model and serial number.
Please note that it will be necessary to
provide proof of purchase for any
in-guarantee service calls.
In-guarantee customers should ensure
that the above checks have been made as
the engineer will make a charge if the fault
is not a mechanical or electrical
breakdown.
SERVICE AND SPARE PARTS
If you require an engineer or spare parts
contact your local Service Force Centre by
telephoning:
0990 929929
Your telephone call will be routed to your local
Service Force Centre. The addresses are
listed in the back of the book.
For general assistance with your appliance or
for further information on Electrolux products
please contact our Customer Care Department.
Customer Care Department,
Electrolux
PO Box 47
Newbury
Berkshire RG14 5XL
Tel: 01635 522 799