Filter
Top Products
40
MOVING YOUR APPLIANCE
You may damage some soft or badly fitted floor
coverings when you move the appliance. The floor
covering under the appliance should be securely fixed
so it does not ruck up when you move the appliance
across it. Alternatively you could remove the floor
covering. This appliance is heavy and care must be
taken when moving it. Do not try to move the
appliance by pulling the door handles.
To move the appliance open the grill door. Raise the
appliance off its front feet by lifting it from inside the
oven. Pull the appliance forward. When you replace
the appliance push it back to the stop and make sure
there is the same gap at each rear corner.
FOR YOUR SAFETY
Do not try to disconnect the appliance from the gas
supply if the supply pipe does not have a bayonet
connection, as described in the installation
instructions. If this is the case contact the person who
installed the appliance.
LOCATION OF APPLIANCE
This appliance must not be installed in a bed-sitting
room of volume less than 20m
3
or in a bathroom,
shower room or garage. It is essential that the
appliance is positioned as Fig 1. a. Shelves, wall
cabinets and cooker hoods must be fitted a minimum
of 650mm directly above the top of the hotplate (or
greater for cooker hoods if recommended by
manufacturers instructions) and 400mm above the
hotplate when fitted in line with the outside of the
appliance. If the units are intended to be fitted
adjacent to the appliance but less than 400mm above
the hotplate, then a minimum space of 50mm must be
maintained between the sides of the unit and the
appliance as Fig 1.b. Curtains must not be fitted
immediately behind the appliance or within 150mm of
the sides of the hotplate. If fitted next to or between
two base units a minimum space of 2mm must be left
between each unit and the sides of the appliance.
The levelling feet fitted to the appliance will achieve a
nominal height to hotplate of 907mm + / - 5mm.
LEVELLING THE APPLIANCE
Adjustment to suit floor conditions or height is
obtained by rotating clockwise or anti clockwise the
feet at the front and rear of the appliance. A spirit
level should be placed on one of the shelves to
confirm the appliance is correctly levelled.
Fig 1.a Fig 1.b