Filter
Top Products
11
In this fully integrated appliance the controls are located on the
top of the door. When selecting a programme, the door needs
to be open.
1. Check that the baskets have been
loaded correctly and that the spray
arms can rotate freely
2. Turn on the water tap
3. Set and start of the programme
Turn the programme selector dial clockwise until the
letter of the programme you wish to select corresponds
with the programme marker on the control panel.
Depress the On/Off push button and close the door. The
machine will start.
4. Interrupting a washing programme
in progress
Interrupt a washing programme in progress ONLY if
it’s absolutely necessary.
Attention! Hot steam may escape when the door is
opened. Open the door carefully.
To interrupt a washing programme
Open the dishwasher door; the programme will stop.
Close the door; the programme will start from the point in
which it was interrupted.
5. End of the washing programme
The dishwasher will automatically stop.
Open the door and wait a few minutes before removing
the dishes; in this way they will be cooler and the drying
will be improved.
Switch off the dishwasher by pressing the On/Off push
button.
6. Unloading the dishwasher
Hot dishes are sensitive to knocks. The dishes should
therefore be allowed to cool down before removing from
the appliance.
Empty the lower basket first and then the upper one; this
will avoid water dripping from the upper basket onto the
dishes in the lower one.
Water may appear on the sides and door of the
dishwasher as the stainless steel will eventually become
cooler than the dishes.
When the washing programme has finished, it is
recommended that the dishwasher is unplugged and the
water tap turned off.
Operating sequence