Filter
Top Products
32 electrolux installation
This appliance has been fitted with
safety features which will prevent the
water used in the appliance from
returning back into the drinking water
system. This appliance complies with
the applicable plumbing regulations.
Always use a new hose-set when
connecting the appliance to the
water mains. An old hose-set must
not be reused. The inlet hose
should be inspected every 12
months for deterioration and
replaced if necessary.
Drain hose
- Connect drain hose to the sink.
Secure it with the supplied hose
clamp.
- Required height: 30 to 100 cm
above bottom of the dishwasher.
- If you use a drain hose extension
the total length should not be longer
than 4 metres. Likewise the internal
diameter of the couplings used for
connections to the waste outlet
must be no smaller than the
diameter of the hose provided.
Ensure the hose is not bent or
squashed as this could prevent or
slow down the discharge of water.
Our appliances are supplied with a
security device to protect against
the return of dirty water back into
the machine.
If the spigot of your sink has a "no
return valve" incorporated this can
prevent the correct draining of your
dishwasher. We therefore advise
you to remove it.
Likewise the internal diameter of the
couplings used for connections to the
waste outlet must be no smaller than
the diameter of the hose provided.
When connecting the drain hose to an
under sink trap spigot, the entire
plastic membrane must be
removed. Failure to remove all the
membrane will result in food particles
building up over time eventually
blocking the dishwasher drain hose
spigot.
117994350.qxp 12/20/2006 5:46 PM Page 32