Filter
Top Products
Microwave Oven / Single Electric Wall Oven
Combination Installation
High standards of quality at Electrolux Major Appliances mean we are
constantly working to improve our products. We reserve the right to change
specifications or discontinue models without notice.
USA
•
250 Bobby Jones Expressway
•
Augusta, GA 30907
•
1-877-4electrolux (1-877-435-3287)
•
electroluxusa.com
CANADA
•
5855 Terry Fox Way
•
Mississauga, ON L5V 3E4
•
1-800-265-8352
•
electroluxca.com
MO_EW INST 08/07 © 2007 Electrolux Major Appliances, NA Printed in the U.S.A.
Microwave Oven/Single Electric Wall Oven
Combination Installation Specifications
•
Always consult local and/or national electric codes.
(Refer to product-specific electrical specifications on this page.)
•
Minimum 24"deep cutout dimension is critical for proper combination
installation, to ensure that each built-in product’s faceplate will fit
flush against cabinet front.
•
Bases must be level and cabinet front must be square.
•
Minimum 4-1/2"required distance from bottom of Wall Oven cutout
to floor, 31"suggested.
•
Respect critical dimensions as noted for proper installation of built-In
products.
•
Minimum 23-1/4" clearance needed for Wall Oven door depth
when open.
30" Built-In Convection Microwave Specifications
•
Product Weight – 60 Lbs.
•
Voltage Rating –120V/ 60Hz/15 Amps
•
Connected Load (kW Rating) @120 Volts =1.55kW
(For use on adequately wired 120V, dedicated circuit having 2-wire
service with a separate ground wire. Appliance must be grounded
for safe operation.)
•
Amps @120 Volts =13 Amps
•
Full base of solid plywood or similar material required, capable of
supporting 100 Lbs.
•
Minimum 3-1/8"clearance required from bottom of Built-In Microwave
cutout to top edge of Wall Oven’s faceplate, leaving a 2"visible area
between both product faceplates.
30" Electric Single Wall Ovens Specifications
•
Product Weights – (E30EW75GPS) 178 Lbs. / (E30EW75GSS) 175 Lbs.
•
Single phase 3- or 4-wire cable, 120/240 or 120/208 Volt, 60 Hertz
AC only electrical supply with ground required on separate circuit fused
on both sides of line.
•
Connected Load (kW Rating) @ 240/208 Volts = 4.0/3.0kW
•
Amps @ 240/208 Volts =16.6/14.4 Amps
•
Full oven base of solid plywood or similar material required, capable of
supporting 200 Lbs.
Note: Refer to Product Installation Guide for detailed instructions
on the web at electroluxusa.com.
24"min. 30"min.
3
1
/8" min.*
3" max.
26
1
/2"min.
27"max.
28
1
/2"min.
28
7
/8"max.
E30EW75GPS
E30EW75GSS
Single Electric
Wall Oven Cutout
Full plywood base
required to support
100 lbs.
28
1
/2"min.
29"max.
E30MO65GSS
Microwave Oven
Cutout
4"x 4" opening
to route armoured
cable
5"
11
1
/2"
120V/60Hz
grounded electrical
outlet should NOT
be located within
shaded area
19
7
/8"min.
20
3
/8"max.
24"min.**
(critical
dimension)
2" min.
31"
suggested
distance
4
1
/2"
min.
required
Bottom cutout
edge must be
finish cut
Full base required
to support 200 lbs.
Electrical junction
box location
For detailed product dimensions
and installation specifications,
refer to model-specific product
sheet and installation instructions
on the web
* Minimum 3
1
/8"
clearance required
from bottom of
Built-In Microwave
Oven cutout to top
edge of Wall Oven’s
faceplate, leaving
a 2"visible area
between both product
faceplates
** Critical dimension –
MUST be applied