Filter
Top Products
16
WARNINGWARNING
WARNINGWARNING
WARNING
Do not attempt to disengage the hinge catches with the door removed from the oven. The hinge
springs could release causing personal injury.
Do not lift or carry the oven door by the handle door.
Figure 4
To remove
oven door,
rotate catch as
shown.
REMOVING THE OVEN DOOR
Open the door to its fully opened position. Rotate the catch over the retaining arm on each
hinge. Lift the oven door to about a 30 degree angle from the horizontal position. Pull the
door away from the oven while continuing to lift.
RE-INSTALLING THE OVEN DOOR
Grasp the oven door on opposite sides and lift it until the door hinges are aligned with the
openings in the oven frame. Holding the door at about a 30 degree angle from the horizontal,
slide the hinges into the openings until the bottom hinge arms drop fully into the two hinge
receptacles. Lower the door to the fully opened position, and then rotate the two hinge
catches toward the oven.
Open and close the door completely to ensure that it is properly installed.
Peel off the protective layer of plastic that covers the door panel.
Installation