Filter
Top Products
10
Operation
FUSE REPLACEMENT
FUSE
FUSE
BOX
ELECTRICAL
BOX
SUPPORT
TRIM
ELECTRICAL BOX
SUPPORT SCREWS
Figure 4
Figure 3
IF LIGHTS FAIL TO OPERATE, DISCONNECT POWER AT THE
SERVICE ENTRANCE. CHECK THE FUSE AND REPLACE IF
NECESSARY
.
1 Remove grease filters.
2 Remove (2) trim screws.
3 Remove trim by pulling it forward.
4 Remove the electrical box support and open the fuse box.
5 Unscrew the cap from the fuse holder and remove the fuse.
6 Replace the fuse with the same size and amperage (5 x 20mm,
4 amp, 125 volt).
7 Replace trim screws and reinstall filters.
8 Reconnect power at the service entrance.
TRIM SCREWS
CAUTION
Use of a fuse greater than 4 amps may damage the transformer.