Filter
Top Products
7
Preparing for Installation
VERIFY PACKAGE CONTENTS
• Literature Pack • Griddle
• Bolts/Washers • Simmer Plate
• Burner Grate Pack • Wok Stand
• Burner Set • Stainless Steel Cleaner
• Gas Pressure Regulator • LP Conversion Kit
• Burner Cap Pack
CABINET/COUNTERTOP PREPARATION
The installation of this built-in appliance must be completed by a qualified appliance
technician or contractor. Proper installation is the owner’s responsibility.
Carefully check the location where the cooktop is to be installed. The cooktop
should be placed for convenient access, but away from drafts that may be caused
by open doors and windows or by HVAC duct outlets. Make certain that gas and
electrical power can be provided in the selected locations. Plan the installation so
that all minimum clearances are met or exceeded. Dimensions shown provide
minimum clearances, unless otherwise noted.
WARNINGWARNING
WARNINGWARNING
WARNING
•To reduce the risk of personal injury caused by reaching over a hot appliance,
cabinet storage space located directly above the cooktop should be avoided.
•Keep appliance area clear and free from combustible materials, gasoline and
other flammable vapors and liquids.
•Failure to provide proper clearances may result in a fire hazard!
•Do not store combustible materials or items adversely affected by heat
immediately above or below the cooktop.
•The back edge of the cooktop must remain a minimum of 2 1/2" (64mm) from any
combustible backsplash material. This will require special cabinet and
countertop dimensions. Installations with less than 2 1/2” from the rear of the
cooktop to a combustible backsplash must use Electrolux Backsplash models
ACCBG096S1 (for E36GC76EPS) or ACCBG0948S1 (for E48GC76EPS).