Filter
Top Products
18
Operation
BEFORE COOKING
Ensure that the cooktop has been installed by a qualified individual who has tested
the operation of the cooktop in accordance with the Installation Instructions. The
brass burner rings, burner caps, grates, knobs and spill protectors must be in
place for the cooktop to operate properly. All cooktop components must be clean.
Be certain that the gas and electrical power supplies to the cooktop are operational.
Read this Use and Care Manual in its entirety prior to operating the cooktop.
OPERATING THE CONTROL VALVES
To light a particular burner, press in on the corresponding control knob, then
immediately rotate the knob counterclockwise from the “OFF” position to the “LITE
HI” position. The burner igniters will spark continuously until the gas ignites
on the selected burner. The igniters will
stop sparking as soon as the burner
ignites.
Once the burner is lit, reduce the flame
height if desired by rotating the control knob
further counterclockwise, then place the
utensil on the grate. See Figure 12.
Figure 12
Burner Control Valve