Electrolux ECM2771 Freezer User Manual


 
Warning:
This appliance must be earthed.
This appliance complies with the
following EC Directives:
-73/23/EEC-Low-VoltageDirective
-89/336/EEC -EMC Directive.
Testing has been carried out in accordance
with EN 153 regarding the determination of
freezer capacity,energy consumption and
temperature rise time.
electrolux cold 9
Installation
Position
Place the freezer horizontally on a
firm surface, resting on all wheels.
Use a wooden block or similar object
to compensate for any bumps/holes in
the surface.
The room should be dry and adequate-
ly ventilated.
Temperatures of the external environment
have an impact on the energy consump-
tion of the freezer. Therefore:
- do not place the freezer in a position
exposed to sunshine or beside a radiator
oven, or any other source of heat.
- position it where the temperature of the
environment corresponds to the
climatic classification for which the
freezer was designed.
Climatic Ambient temperature
classification limits
From….to
SN +10 to +32 C
N +16 to +32 C
ST +18 to +38 C
T +18 to +43 C
If the freezer has been handled in a
vertical position it should be allowed to
stand in normal position for about 12
hours before switching it on.
Please ensure that when the appliance
is installed it is easily accessible for the
engineer in the event of a breakdown.
Electrical Connection
Any electrical work required to install this
appliance should be carried out by
a qualified electrician or compe-
tent person.
This appliance must be earthed.
The manufacturer declines any liabili-
ty should these safety measures not
be observed.
Electrical Requirements
Before switching on, make sure the elec-
tricity supply voltage is the same as that
indicated on the appliance rating plate.
The appliance is supplied with a 13amp
plug fitted. In the event of having to
change the fuse in the plug supplied, a
13amp ASTA approved (BS1362) fuse
must be used.Should the plug need to be
replaced for any reason. The wires in the
mains lead are coloured in accordance
with the following code: