Filter
Top Products
electrolux electrolux
electrolux electrolux
electrolux control panel
99
99
9
GB
Filter checking deviceFilter checking device
Filter checking deviceFilter checking device
Filter checking device
The cooker hood is fitted with a
device which indicates when the filter
must be cleaned or replaced.
Usually the device, which signals
when the carbon filter needs
maintenance work, is
deactivateddeactivated
deactivateddeactivated
deactivated.
To activate it, proceed as follows:
Switch off the cooker hood.
Press the knob and rotate it by 90° in
a clockwise direction.
The
L2L2
L2L2
L2 LED begins to flash in green
and after approximately 2 seconds
the
L2L2
L2L2
L2 LED will also begin to flash in
orange, to indicate that the device,
which indicates when it is necessary
to perform carbon filter maintenance,
has been
activatedactivated
activatedactivated
activated.
L2 LED - grL2 LED - gr
L2 LED - grL2 LED - gr
L2 LED - gr
ease filter indicatorease filter indicator
ease filter indicatorease filter indicator
ease filter indicator
The LED lights up in green when the
grease filter needs to be cleaned; this
happens approximately every 40
hours of operation.
Every time the cooker hood is used,
check whether the
L2L2
L2L2
L2 LED is lit.
L2 LED - carbon filter indicatorL2 LED - carbon filter indicator
L2 LED - carbon filter indicatorL2 LED - carbon filter indicator
L2 LED - carbon filter indicator
The LED lights up in orange when
the carbon filter needs to be cleaned/
replaced; this happens approximately
every 160 hours of operation.
Every time the cooker hood is used,
check whether the
L2 L2
L2 L2
L2 LED is lit.
Resetting the filter saturation warResetting the filter saturation war
Resetting the filter saturation warResetting the filter saturation war
Resetting the filter saturation war
ningning
ningning
ning
After cleaning or replacing the filters,
switch on the cooker hood at any
suction speed (power), then press
and hold the knob for more than 3
seconds, until you hear a beep
indicating that the reset procedure
has been performed successfully.
The
L2L2
L2L2
L2 LED and the cooker hood
both switch off.
In some situations (for example,
when the
L2L2
L2L2
L2 LED is indicating that
the grease filters and the carbon filter
are saturated), the procedure
described above must be repeated.