Filter
Top Products
43
Active carbon filter
When the hood is used in recirculation mode an active carbon filter should be used.
Order by the retailer: PNC 942 120 182
Special accessories
Installation
Unpacking
Check that the cooker hood has no damages.
Transportation damages should immediately be
reported to the one responsible for the transport
Damages, faults and eventually missing details
should immediately be reported to the seller.
Take care of the packing material so that small
children cannot play with it.
Placement
The hood is to be mounted on the wall.
When installed, the hood must be not less than 65
cm. above electric burners or 75 cm. above gas or
mixed-fuel burners. (Fig. 3).
Electrical connection
The hood has a power cord with moulded plug
with earth connection to be connected to a wall
outlet of 230 V.
The power outlet should be pre-mounted in such a
way that the power cord is invisible when the hood
is fully mounted.
The power cord length is 1,25 m.
As it is then hard to disconnect the
power plug for cleaning and service,
an easy accessible two pole switch
should be fitted. The switch should conform to
regulations with an opening distance between
contacts of not less than 3 mm.
Min
75 cm
Min
65 cm
Fig. 3