Filter
Top Products
14
Fitting the Cooker Hood to the Wall
1. Fit the brackets with the round ends facing
downwards using the plastic rawl plugs and
screws provided.
2. Once the brackets are secured, lift the hood
squarely to the wall slightly higher than the
brackets and lower the cooker hood until it is
located onto the two brackets.
Ensure that the cooker hood is correctly
located before letting go.
3. By loosening the screws in the extension arm
the hood can be aligned with the front of the
adjoining wall cabinets.
4. The hood should be secured on each side to
the adjoining wall cabinets using the 4 x 15mm
(1/2 ins) security screws provided.
5. Adjust the lower spacer panel at the rear of the
hood to close the gap to the wall.
Decor Panel
The dimensions of the door panel should be 596mm
(23 1/2 ins) wide by 350mm (13 3/4 ins) in height.
Fitting a Decor Panel to the Hood
Visor
1. Remove the complete visor assembly by first
pulling the visor open while simultaneously
pressing down on the release catch located
behind the visor on the left hand side of the
casing.
2. Using the paper template provided, mark the
screw hole positions on the reverse side of the
decor panel. Ensure that the paper template is
aligned with the top edge of the decor panel.
Failure to align the top edge of the decor panel
with the template will prevent the visor from
opening when installed.
3. Before drilling, use a tape measure to check
the distances of the screw holes (as given on
the template). The template may have altered
due to dampness after manufacture.
4. Use the 6 x 15mm (1/2 ins) round headed
screws provided to attach the decor panel to
the hood visor.