Filter
Top Products
Warning
Failure to observe the instructions on cleaning
the unit and changing the filters will cause a
fire hazard. You are therefore strongly
recommended to follow these instructions.
The manufacturer declines all responsibility for
any damage to the motor or any fire damage
linked to inappropriate maintenance or failure
to observe the above safety recommendations.
Cleaning the hood
Clean the outside of the hood using a damp
cloth and a mild detergent.
Never use corrosive, abrasive or flammable
cleaning products.
Never insert pointed objects in the motors
protective grid.
Wash the outside surfaces using a delicate
detergent solution. Never use caustic detergents
or abrasive brushes or powders.
Only ever clean the control panel and filter
grille using a damp cloth and delicate
detergents.
It is extremely important to clean the unit and
change the filters at the recommended intervals.
Failure to do so will cause grease deposits to
build up that could constitute a fire hazard.
Grease filter
The purpose of the grease filters is to absorb
grease particles which form during cooking and
it must always be used, either in the external
evacuation or internal recycling function.
The synthetic filter is very thin (approx. 1 mm)
and positioned on the inside of its related
support grille.
The filter should be changed once a month.
The grille should be cleaned with luke warm
water and non-abrasive detergent when you
change the filter.
The grease filter can be ordered from your local
ELECTROLUX Service Force Centre.
Opening the grid (Only EFI 635)
Move the two sliders towards the centre (in the
OPEN direction) and release the grille
downwards. Fig. 5a.
To refit the filter: it should be inserted above
between the appropriate guides until it latches
into place, and after having propped the grille
to the cooker hood also in the lower part move
the two sliders outwards (in the CLOSED
direction).
Removing the metal grease filters
First pull the handles upwards, then extract the
filters outwards. Fig. 5b.
To refit: they should be inserted above between
the appropriate guides until it latches into place,
and after having attached the grille to the
cooker hood also in the lower part. Fig. 5b.
Removing the filter
Remove the stops to take out the filter. Fig. 6.
The hood must always be disconnected from the electricity supply before beginning any maintenance
work.
Maintenance and Care
Stops
Fig. 6
Fig. 5a - EFI 635
Fig. 5b - EFI 640
Guides
OPEN
CLOSED
OPEN
CLOSED
Guides