Filter
Top Products
electrolux electrolux
electrolux electrolux
electrolux installation
7171
7171
71
GB
Fitting the charFitting the char
Fitting the charFitting the char
Fitting the char
coal filter for rcoal filter for r
coal filter for rcoal filter for r
coal filter for r
ecirecir
ecirecir
ecir
culation versionculation version
culation versionculation version
culation version
If the extractor hood is installed as a return air appliance (Recirculation version -
air outlet above the wall unit), the charcoal filter (available from your local Service
Force Centre) must be fitted before the grease filters are fitted.
Installation sequence:Installation sequence:
Installation sequence:Installation sequence:
Installation sequence:
1. Insert the holding frame for the charcoal filter in the shaft of the hood with the
2 lugs facing upwards and then clip into the lower holes.
2. Fix the holding frame on the lower part of the housing of the hood with the 2
screws supplied.
3. Fit the charcoal filter (see paragraph “Charcoal filter”)
4. Refit the grease filters. Push-in the visor.
Removing the hood frRemoving the hood fr
Removing the hood frRemoving the hood fr
Removing the hood fr
om the wall unitom the wall unit
om the wall unitom the wall unit
om the wall unit
If, for technical reasons (extraction version/recirculation version conversion) the
extractor hood has to be removed from the wall unit, proceed as follows:
• Fully withdraw the visor and remove the grease filter.
• Loosen the 4 or 6 mounting screws of the hood (wall unit mounting).
• To loosen both mounting claws (installation aids), place a max 3 mm dia. Phillips
screw-driver in the spring opening and simultaneously press the springs
inwards (towards the appliance housing).
Important: Hold the hood firmly!Important: Hold the hood firmly!
Important: Hold the hood firmly!Important: Hold the hood firmly!
Important: Hold the hood firmly!