Filter
Top Products
what to do if … electrolux 29
What to do if …
Problem Possible cause Remedy
The appliance cannot be
switched on or is not operating
More than 10 seconds have
passed since the appliance
was switched on
Switch the appliance on again.
The lock is switched on Switch off the lock (See the
section “Locking/unlocking
the control panel”)
The child safety device is
switched on
Deactivate child safety device
(See the section “Child safety
device”)
Several sensor fields were
touched at the same time
Only touch one sensor field
Safety cut-out has been trig-
gered
Remove any objects (pan,
cloths, etc.) that are lying on
the control panel. Switch the
appliance on again
The residual heat indicator is
not displaying anything
The cooking zone was only on
for a short time and is therefore
not hot
If the cooking zone is sup-
posed to be hot, call the Cus-
tomer Service Department.
The automatic warm up func-
tion is not switching itself on
There is still residual heat on
the cooking zone
Let the cooking zone cool
down
The highest heat setting is set
The highest heat setting has
the same power as the auto-
matic warm up function
Sensor fields are getting hot Cookware too big or placed
too near the controls
Place cookware in the middle
on one of the four cooking
zoznes. Place large cookware
on the back cooking zones in
preference.
Repeated acoustic signal (6x),
appliance switches off
One or more sensor fields
have been covered for longer
than 10 seconds
Uncover sensor field
Acoustic signal sounds when
appliance is switched off
The control panel is wholly or
partly covered by objects.
Remove objects.
Acoustic signal sounds and
appliance switches itself on
and then off again; after 5 sec-
onds another acoustic signal
sounds
The On/Off sensor field has
been covered up, e.g. by a
cloth
Do not place any objects on
the control panel
Display changes between two
heat settings
Power Management is reduc-
ing the power of this cooking
zone
See the section “ Switching
the power function on and off”
Power Management is active,
maximum load per side
reached
Use cooking zones on other
side