Filter
Top Products
7
Door Handle Mounting Instructions
Ensure Handle Set Screws
are Facing to the outside
edge of door.
B
A
B
Lower End Cap
A
B
Upper End Cap
Installation
NOTE
All set screws should be tightened and sub-flush (Allen set screw should be seated just below the surface of
the end cap) of handle end cap. The end caps should be drawn tight against the door with no gaps.
1 Remove handle from carton and any other protective packaging.
2 Position handle end caps over upper and lower pre-installed
shoulder bolts (A) that are fastened into door, ensuring the holes
for the set screws are facing towards the outside edge of the door.
3 While holding handle firmly against door, fasten upper and lower
Allen set screws (B) with supplied Allen wrench.