Filter
Top Products
6
Installation 1982 (Manufactured Home Sites, Commu-
nities and Setups) ANSI A225.1/NFPA 501A, or latest
edition, or with local codes.
Cabinet Dimensions
IMPORTANT:
Minimum distance “X”: 24” (61 cm) from electric cooking surfaces.
Minimum distance “X”: 30” (76.2 cm) from gas cooking surfaces.
Suggested maximum distance “X”: 36” (91.4 cm).
Location Requirements
IMPORTANT: Observe all governing codes and ordi-
nances. Have a qualied technician install the hood
insert. It is the installer’s responsibility to comply with
installation clearances specied on the model/serial
rating plate. The model/serial rating plate is located
behind the left lter on the rear wall of the hood
insert.
The hood insert location should be away from strong
draft areas, such as windows, doors and strong heat-
ing vents.
Cabinet opening dimensions that are shown must be
used. Given dimensions provide minimum clearance.
The hood insert must be surrounded by a custom built
enclosure with hood cabinet capable of supporting 75
lb (34 kg).
Grounded electrical outlet is required. See “Electrical
Requirements” section on page 5.
All openings in ceiling and wall where canopy hood
will be installed must be sealed.
For Mobile Home Installations
The installation of this hood insert must conform to the
Manufactured Home Construction Safety Standards,
Title 24 CFR, Part 328 (formerly the Federal Standard
for Mobile Home Construction and Safety, Title 24,
HUD, Part 280) or when such standard is not appli-
cable, the standard for Manufactured Home
“X” bottom of canopy to
cooking surface
Hood insert cabinet must be
capable of supporting
75 lb (34 kg)
22”
(55.9 cm)
Hood insert
depth
Location requirements
Product dimensions
30” (76.2 cm) for 30” models
36” (91.4 cm) for 36” models
48” (121.9 cm) for 48” models
9
7
/8” (25.11 cm)
22” (55.9 cm)
10 1/8” (25.7 cm) for 36 & 48” models
11” (28 cm)
15” (38 cm) for 30” models
18” (45.2 cm) for 36” models
24” (61 cm) for 48” models
8
”
(31.4 cm)
(29.2 cm)
16
” (12.2 cm)
16
”
(12.8 cm)
24
5
/
16
”(61.8cm) for 30” models
30” (75.8 cm) for 36 & 48” models
30” (76.2 cm) for 30” models
36” (91.4 cm) for 36” models
48” (121.4 cm) for 48” models
22” (56 cm) for 30”models
27
1
/
2
”(70 cm) for 36 & 48”models
11” (28 cm) for 30” model
30” model
wiring knockout
36” & 48” models
wiring knockout