Filter
Top Products
31
MOVING YOUR APPLIANCE
You may damage some soft or badly fitted floor
coverings when you move the appliance. The floor
covering under the appliance should be securely
fixed so it does not ruck up when you move the
appliance across it. Alternatively you could remove
the floor covering. This appliance is heavy and care
must be taken when moving it. Do not try to move
the appliance by pulling the door handles.
To move the appliance open the grill door. Raise
the appliance off its front feet by lifting it from inside
the oven. Pull the appliance forward. When you
replace the appliance push it back to the stop and
make sure there is the same gap at each rear
corner.
FOR YOUR SAFETY
Do not try to disconnect the appliance from the gas
supply if the supply pipe does not have a bayonet
connection, as described in the installation
instructions. If this is the case contact the person
who installed the appliance.
LOCATION OF APPLIANCE
This appliance must not be installed in a bed-sitting
room of volume less than 20m
3
or in a bathroom,
shower room or garage. It is essential that the
appliance is positioned as Fig 1. a. Shelves, wall
cabinets and cooker hoods must be fitted a minimum
of 750mm directly above the top of the hotplate (or
greater for cooker hoods if recommended by
manufacturers instructions) and 400mm above the
hotplate when fitted in line with the outside of the
appliance. If the units are intended to be fitted
adjacent to the appliance but less than 400mm
above the hotplate, then a minimum space of 50mm
must be maintained between the sides of the unit
and the appliance as Fig 1.b. Curtains must not be
fitted immediately behind the appliance or within
150mm of the sides of the hotplate. If fitted next to
or between two base units a minimum space of 2mm
must be left between each unit and the sides of the
appliance. The levelling feet fitted to the appliance
will achieve a nominal height to hotplate of 900mm +
20mm.
Note:- L.P.G. cookers MUST NOT be installed
below ground level i.e. in a basement or aboard any
boat, yacht or other vessel.
LEVELLING THE APPLIANCE
Adjustment to suit floor conditions or height is
obtained by rotating clockwise or anti clockwise the
feet at the front and rear of the appliance. A spirit
level should be placed on one of the shelves to
confirm the appliance is correctly levelled.
Fig 1.a Fig 1.b