Filter
Top Products
ATTENTION:
The temperature shown on the control panel corresponds to the
temperature in the centre of the oven only when the functions selected
are or .
When you turn the control knob to this position, the light will be on for
all the following operations.
4
To operate the turnspit, turn the knob to position .
To use the turnspit follow the instructions below.
- Thread the chicken or cubes of meat for roasting on the spit L.
Ensure that it is secured properly between the two forks F and
balance it correctly to avoid unnecessary strain on the transmission
R (fig 3A).
- Rest the spit on the support G, after having fitted the opposite
end into socket P of the transmission R (fig 3A)
- Place the support G in the oven so that the bar I goes into the
socket H of the turnspit motor M (fig 3B).
- Place the drip-tray with some water under the turnspit, on the
lowest level
- Wear oven gloves to remove the spit and pull out support G.
To operate the turnspit, turn the knob to position (fig 3C).
TURNSPIT (mod. EKM 90310 X)
TURNSPIT (mod. EKM 90410 X)
Fig. 3
Defrosting with fan
Ambient temperature air is distributed inside the oven, allowing you
to defrost food very quickly and without loss of protein.
Natural convection
Both the lower and upper heating elements operate together.
This is the traditional cooking function, which is ideal for roasting
joints, baking biscuits, making baked apples and crisping food.
This function gives excellent results when cooking on one shelf, with
the temperature set between 60 and MAX°C.
Fan oven
Both the fan and the circular heating element operate together.
The hot air, which can be set between 60 and MAX°C, is uniformly
distributed inside the oven. This function is ideal for cooking several
types of food (meat, fish), without affecting taste and smell.
It is also perfect for delicate pastries.
Display
4-digit, 7-section display for cooking times and clock.
Cooking time and manual function = saucepan symbol
Automatic function = AUTO
Minutes minder = bell symbol
The symbols light up when the corresponding functions are selected.
“LED” PROGRAMMER (Fig. 4A)
Features
24 hours clock with automatic timer and minute minder.
Functions
Cooking time, cooking end time, manual position, clock,
minute minder, maximum programmable time 23 hours 59 minutes.
GB
Medium grill (+ turnspit according to the models)
This function is ideal for grilling small quantities of traditional food and
cooking au gratin dishes.
The thermostat knob must be set to the maximum temperature.
Total grill (+ turnspit according to the models)
This function is ideal for grilling traditional food and cooking au gratin
dishes.
Set the thermostat control knob to 200°C.
Fan assisted total grill (+ turnspit according to the models)
The air is heated by the grill heating element and circulated by means
of the fan, which distributes the heat over the food.
The fan assisted grill is a perfect alternative to the turnspit. It also
gives excellent results also for large quantities of poultry, sausage
and red meat. Turn the thermostat control knob to 200°C.
Fan assisted lower heating element
The air is heated by the lower heating element and circulated by
means of the fan, which distributes the heat over the food.
This function can be used to sterilize food. Set the thermostat contol
knob between 60 and MAX°C
To use the turnspit follow the instructions below.
- Thread the chicken or cubes of meat for roasting on the spit L.
Ensure that it is secured properly between the two forks F and
balance it correctly to avoid unnecessary strain on the transmission
R (fig 3).
- Rest the spit on the support G, after having fitted the opposite
end into socket P of the transmission R (fig 3)
- Place the drip-tray with some water under the turnspit, on the
lowest level.
- Wear oven gloves to remove the spit.
R L F
P
G
Fig. 3A
Fig. 3B
I
R
G
M
H
Fig. 3C
MINUTES COUNTERS (Fig.4)
Turn the knob clockwise to set the desired cooking time.
The minutes minder can be adjusted from 1 to 60 minutes.
A sound signal will inform you that the chosen time is up.
Fig. 4
INSTRUCTIONS FOR USING THE CONTROL DEVICE
USING THE TURNSPIT (according to the models)
L
F
R
P
G