Filter
Top Products
Setting
To set, press and release the desired function, and within 5 seconds
set the time using the + and - buttons.
+ and - buttons.
The + and - buttons increase and decrease the time respectively the
speed depending on how long the button is pressed.
Setting the time
Press any two buttons manual at the same time, and + or - button to
set the desired time. This deletes any previously set programme. The
contacts are switched off and the AUTO symbol flashes.
5
it when it shows any sign of wear. Do not under any cincumstances
attempt to repair the gas hose.
ENAMELLED SURFACES
Clean with a damp sponge using soap and water.
Grease can be easily removed using hot water or a specific cleansing
agent for enamelled surfaces. Do not use abrasive cleansers.
Do not leave any acid or alkaline substances (lemon juice, vinegar,
salt, etc.) on the enamel.
Clean the parts in stainless steel with specific cleansers for stainless
steel surfaces.
These detergents must be applied using a soft cloth.
GRIDS AND BURNERS
To clean the cooktop burners, remove by pulling upwards and soak
them for approximately 10 minutes in hot water with a little detergent.
After cleaning and washing them, dry them carefully.
Make sure that burner holes are not clogged.
Clean the burners once a week or more frequently if necessary.
MAKE SURE YOU HAVE ASSEMBLED THE BURNERS
CORRECTLY.
OVEN
Clean enamelled parts with a damp sponge using soap and water.
Grease can be easily removed using hot water or a specific cleansing
agent for enamelled surfaces.
Do not use abrasive cleansers.
Install shelves by locating them in the horizontal guide rails
on the oven walls.
Manual use
When the manual button is pressed the relay contacts switch on, the
AUTO symbol switches off and the saucepan symbol lights up.
Manual operation can only be enabled after the automatic programme
is over it has been cancelled.
Automatic function
Press the cooking time or end time button to switch automatically from
the manual to the automatic function.
Before cleaning the appliance, turn off the mains gas tap and
unplug the appliance or disconnect power at the main circuit
breaker of the electrical system.
Do not clean appliance surfaces when still hot.
Do not use steam cleaners to clean the oven.
IMPORTANT
Periodically check the external gas connection hole and replace
WARNINGS
Do not use the oven door handle to move the appliance, for example
to remove it from the packaging.
The appliance is in class 1 or class 2 subclass 1.
IMPORTANT: Any adjacent furniture must be able to withstand high
temperatures (min. 90°C).
If the appliance is to be installed near units, leave the minimum gaps
specified in the table below.
Setting error
A setting error is made if the time of day on the clock falls within the
cooking start and end times.
To correct the setting error, change the cooking time or cooking end
time.
The relays switch off when a setting error is made.
Cancelling a setting
To cancel a setting, press the cooking time button and then press
the - button until 00 00 appears on the display.
A set programme will automatically cancel on completion.
The relay switches on. When the cooking end time button is pressed
the next cooking end time is shown on the display. Set the cooking
end time with + button. The relay and the cooking time symbol switch
off.
The symbol lights up again when the cooking start time is reached.
When the cooking time is finished, the AUTO symbol flashes, the
acoustic signal sounds and both the cooking time symbol and the
relay switch off.
Minutes minder
Press the minute minder button and set the cooking time with + or -
button.
The bell symbol lights up when the minutes minder is operating
When the set time is finished, the acoustic signal sounds and the bell
symbol switches off.
Semi-automatic use to set cooking time
Press the cooking time button and set the desired time with + or -.
The AUTO and cooking time symbols light up continuously. The relay
switches on immediately. When the cooking end time is reached, the
relay and cooking time symbol switch off, the acoustic signal sounds
and the AUTO symbol flashes.
Semi-automatic use to set end time
Press the end time button. The time of day appears on the display.
Set the cooking end time with + button. The AUTO and cooking time
symbols light up continuously. The relay contacts switch on. When
the cooking end time is reached, the relay and the cooking time
symbol switch off. When the cooking time is finished, the AUTO
symbol flashes, the acoustic signal sounds and both the relay and
the cooking time button switch off.
Automatic use to set cooking time and end time
Press the cooking time button and select the duration of the cooking
time with + or - button. The AUTO and cooking time symbols light up
continuously.
GB
Acoustic signal
The acoustic signal sounds at the end of a programme or of the
minutes minder function and it lasts for a maximum of 15 minutes.
To stop it, push any one of the functions buttons.
Start programme and check
The programme starts 4 seconds after it has been set.
The programme can be verified at any time by pressing the
corresponding button.
Fig. 4A
CARE AND MAINTENANCE
INSTRUCTIONS FOR THE USER
OVERALL DIMENSIONS
895
1450/1500
600
100
850/900
910/960
A
U
T
O
Minute minder
Cooking time
Cooking end
Manual
Decrease time
Increase time