Electrolux ERES31800 Refrigerator User Manual


 
16
When the refrigerator is to be used
again, rinse the system through
thoroughly by draining off at least three
litres (5 pints) of water.
If necessary, all systems containing
water must be sanitized by ordering
the necessary sanitizing kit through
Electrolux Service Force Centre
(tel: +44 8705 929 929) or through our
website www.electrolux.co.uk.
Service during operation
The water filter is replaced as follows:
Place a piece of kitchen tissue or a
dishcloth in the space under the filter.
Remove the filter by turning it
clockwise. A small amount of water will
run out. Dry off and fit the new filter.
See the section " When starting the
water system for the first time".
The water connection does not need
to be switched off when changing the
filter.
Replacement filters can be ordered
from Electrolux Service Force Centre.
See the section "Service and
replacement parts".
The gas cylinder is replaced as follows:
remove the gas cylinder and transfer
the adapter to the new cylinder.
The replacement gas cylinder is
obtained through your local dealer.
To change the lamp
The light is switched on automatically
when the door is opened. Before
replacing the light bulb, disconnect the
power plug fro m the outlet.
Disassemble the lamp by using a
screwdriver in the recess on the lamp
insert. To prise it out of its location.
Assemble a new lamp by guiding it
into a centred position and press until
it snaps into place.
Use a halogen bulb of the same type,
maximum rating of 20 W.
Change of carbon filter
To main tain the best performance the
carbon filter should be changed once
a year with n ormal usage.
New carbon filters can be purchased
from your local dealer. The filter is
placed behind the grill and can be
reached by opening the cover. The
cover can be opened by simulta-
neously pressing the lever on the right
of the grill (1) and turning the cover
outward (2). The carbon filter is then
pulled out of its slot (3).
The new carbon filter is placed in the
existing slot - The filter should be
handled carefully so fragments do not
loosen from the surface.
1
2
3