Filter
Top Products
First try to find a solution to the problem (re-
fer to the chart). If not, contact the service
centre.
Malfunction Fault code Possible cause Possible solution
The appliance
does not fill with
water.
• The start/cancel indicator
light flashes.
• The end-of-programme
indicator light flashes one
time.
The water tap is
blocked or is furred with
limescale.
Clean the water tap.
The water pressure is
too low.
Contact your local wa-
ter authority.
The water tap is closed. Open the water tap.
The filter in the water in-
let hose is blocked.
Clean the filter.
The connection of the
water inlet hose is not
correct.
Make sure that the
connection is correct.
The water inlet hose is
damaged.
Make sure that the wa-
ter inlet hose has no
damages.
The appliance
does not drain
the water.
• The start/cancel indicator
light flashes. .
• The end-of-programme
indicator light flashes two
times.
There is a blockage in
the sink spigot.
Clean the sink spigot.
The connection of the
water drain hose is not
correct.
Make sure that the
connection is correct.
The water drain hose is
damaged.
Make sure that the wa-
ter drain hose has no
damages.
The programme
does not start.
The appliance door is
open.
Close the door correct-
ly.
The mains plug is not
connected in.
Put in the mains plug.
Blow out fuse in the
household fuse box.
Replace the fuse.
The delay start is set. If you want to cancel
the delay start, refer to
'Select and start a
washing programme'.
After the check, switch on the appliance.
The programme continues from the point of
interruption.
If the malfunction shows again, contact the
service centre.
For other fault codes, not showed in the
chart, contact the service centre.
The necessary data for the service centre is
on the rating plate.
We recommend that you write the data
here:
Model (MOD.) ....................
Product number (PNC) ....................
Serial number (S.N.) ....................
electrolux 13