Filter
Top Products
Fitting under a counter
(kitchen worktop or sink)
By removing the machine’s worktop, you can install it under a
close fitting sink unit or a pre-existing top, providing the
dimensions of the recess correspond to those shown in the
picture.
Proceed as follows:
- Remove the machine’s worktop by unscrewing the
two rear retaining screws, pull from the front and
slide out the rear slots, lifting the worktop.
Insert the machine after adjusting height and levelling with the
adjustable feet. When inserting the machine, ensure that the
water inlet and drain hoses are not kinked or squashed.
Levelling
Good levelling is essential for correct closure and sealing of
the door.
When the appliance is correctly levelled, the door will not catch
on the levelling spacers on either side of the cabinet.
If the door does not close correctly, loosen or tighten the
adjustable feet until the machine is perfectly level.
Protection against flooding
In order to prevent water floods, the machine has been
provided with an additional device in the bottom of the machine
to protect against flooding.
The device will operate if there are any water leaks in the
machine, however it will only operate if the machine is on.
In case of malfunction to repair the dishwasher, turn off the
water tap and call the Service Force Centre.
11
820
570 - 600
600
IN05
The products
In order to obtain a good wash, it is necessary to use
detergents specially designed for dishwashers.
To ensure that your dishwasher functions perfectly, Zanussi
recommends using Calgonit System, a unique and complete
product, tested by millions of householders.
Calgonit System includes Calgonit detergent, rinse aid, salt,
machine detergent and Citro-Fresh.
It is able to fulfil the main requirements for clearing both the
crockery and the machine itself.