Filter
Top Products
17
Starting the Wash Programme
1. Check that the dishes and cutlery are loaded into
the dishwasher in such a manner that the spray
arms are free to rotate.
2. Open the tap fully.
3. Close dishwasher door.
4. Turn the programme switch clockwise to A,orB or
C (see „ Programme Table“).
1
For interference suppression reasons, only
operate the programme switch with the dish-
washer switched off. It is also possible that
the automated addition of detergent will be
triggered.
5. Turn the programme selector to the required pro-
gramme (see „ Programme Table“).
The selected wash programme starts. The pro-
gramme switch rotates during the wash pro-
gramme and indicates the position that has been
reached in the programme.
1
If a wash programme has been started even
though the tap was closed, turn the pro-
gramme selector to the I position, open the
tap and start the programme again.
Changing/Interrupting the Wash
Programme
3
Only change or interrupt a wash programme
in progress if it is absolutely necessary.
When the appliance is closed again, the air
that has entered is heated rapidly and
expands. This can cause water to escape
onto the floor and possibly trigger the anti-
flood system.
Changing the wash programme
1. Turn the program selector to the I position. Wash
programme stops.
1
Hot steam can escape when the door is
opened. There is a risk of scolding! Open the
door carefully.
2. Open dishwasher door and check whether there is
still detergent in the container. Refill the container
if necessary.
3. Close dishwasher door.
4. Turn the programme switch clockwise to A,orB or
C (see „ Programme Table“).
5. Turn the programme selector to the required pro-
gramme (see „Programme Table“). Wash pro-
gramme starts.
Interrupting the wash programme by
opening the door of the dishwasher
1
Hot steam can escape when the door is
opened. There is a risk of scolding! Open the
door carefully.
1. Open the door of the dishwasher. The wash pro-
gramme stops.
2. Shut the door. The wash programme continues.