Electrolux ESII Range User Manual


 
Oven Control Style 1 or
2 - Customizing Your
Oven Performance
Note: The adjustments made will not
change the self-cleaning temperature.
The temperature in the oven has been set at the factory. When first using the
oven, be sure to follow recipe times and temperatures. If you think the oven
is too hot or too cool, the temperature in the oven can be adjusted. Before
adjusting, test a recipe by using a temperature setting that is higher or lower
than the recommended temperature. The baking results should help you to
decide how much of an adjustment is needed.
To Adjust Oven Temperature - Control Style 1
1. With the dial set to OFF, press and hold_ for 30 seconds until
a single beep is heard.
2. Within 5 seconds, turn the Temperature Control Knob clockwise to either
the High (HI) or Low (LO) Broil setting. Select High Broil (HI) to increase the
temperature or Low Broil (LO) to decrease the temperature.
3. The temperature can be adjusted up or down 35°F, in 5°F steps, by pressing
START. Adjust until the desired amount of offset is indicated by the
indicator lights as follows:
A flashing "OVEN" indicator light indicates a positive offset, while a flashing
"LOCK" indicator light indicates a negative offset. The lights will flash once
for each 5°F of offset. If no light isflashing, the oven control has the original
factory calibration, and the offset is 0°F. Example: If the OVEN indicator
light is flashing three times and then pauses, the offset is + 15°F.
4. When you have made the desired adjustment, turn the Temperature
Control Knob to OFF.
To Adjust Oven Temperature - Control Style 2
1. With the dial set to OFF, press and hold__'_ for 30 seconds until
a single beep is heard.
2. Within 5 seconds, turn the Temperature Control Knob clockwise to either
the High Broil (HI) or Low Broil (LO) setting.
3. The display now indicates the amount of degrees offset between the
original factory temperature setting and the current temperature setting.
If the oven control has the original factory calibration, the display will read
"00."
4. The temperature can now be adjusted up or down 35°F, in 5°F steps, by
pushing and holding_ or _. Adjust until the desired amount of
offset appears in the display.
5. When you have made the desired adjustment, turn the Temperature
Control Knob to OFF.
17