Filter
Top Products
- 10 -
Starting the programme
1. Scrape or rinse off solid food remnants.
2. Load the dishwasher.
(See the basket and loading).
3. Put the correct amount of detergent into the
detergent dispenser and close the lid.
4. Press in the On/Off button. All programme
indicator lamps are lit.
5. Press in the required programme button (see pro-
gramme chart). All other programme indicator
lamps go out.
6. Close the door.
7. Check the strainers/filters to see if they need to
be cleaned when the dishwasher has finished
the programme.
Interrupting the programme temporarily
1. Open the door. The programme stops.
2. The programme indicator lamp is lit.
3. Close the door and the programme continues
after about 6 seconds.
Open the door carefully when the dishwasher
is running, since hot steam may escape.
Cancelling the programme
1. Open the door.
2. Press and hold in the combination buttons,
the machine goes to starting position and all
programme indicator lamps are lit.
3. Release the buttons. The programme is now
cancelled and a new programme can be
selected.
If you switch the dishwasher off with the On/Off
button, the selected programme is not finished, it
is only disrupted. When you start the dishwasher
again, the programme will continue.
Pause function
With the pause function the programme can be temporarily
interrupted for a short period of time.
1. Open the door and press the On/Off button. The
programme stops.
2. All lamps go out.
3. When you want the programme to continue again,
press the On/Off button once more and close
the door. The programme continues.
The programme should not be paused for any
longer then necessary, because the water inside
the dishwasher has cooled down and must be
heated again which increases the power
consumption.
Cancelling the drying phase
In case you do not want to wait until the drying phase is
completed, you can cancel it by opening the door. The
drying phase is now cancelled.
Switching the dishwasher off
Switch the dishwasher off when the buzzer for completed
programme sounds (approx. 15 seconds) or the lamp for
the completed programme cycle is lit.
1. Open the door and press the On/Off button.
2. Leave the door slightly ajar.
Be careful if you open the door immediately
after the programme is finished, since hot
steam may escape.
This dishwasher is equipped with the new flush
system called ”IMPULSE WASHING”. This
washing system varies both the revolutions of
the pump and the water pressure for more inten-
sive cleaning of the dishes during a programme.
That is why different sections of the programme
cycle do not sound the same.
Using the appliance