Filter
Top Products
- 6 -
Combination buttons ”A”
In addition to selecting a programme, you can by
pressing these two buttons adjust the setting of the
water softener, switch off the buzzer and cancel a
programme in progress.
Control lamps:
Shows that • Refilling of salt is necessary
• Refilling of the rinse aid
is necessary
• Programme cycle completed
The control panel
Programme
buttons
Water softener
button
Buzzer
button
On/Off button
Delay start
button
Indicator lamps
delayed start
Control-
lamps
Switching the buzzer off
Before switching the buzzer off all programmes must have
completed.
1. Press in the On/Off button in.
2. Press the combination buttons simultaneously
and hold them pressed in. When the first three
programme indicator lamps start to flash, you
can release the buttons.
3. Press the buzzer button once. The lamp for the
buzzer button start to flash and the lamp for the
completed programme cycle is lit. Press the
button once more and the lamp for the completed
programme cycle goes out. The buzzer is now off.
4. Press out the On/Off button to complete the setting.
To reset the function, follow steps 1 and 2 above
and then press the buzzer button twice, until
the lamp for the completed programme cycle is
lit again.
Setting the delay start
The programme start can be delayed by 3, 6 or 9 hours.
1. Press in the On/Off button.
2. Press the delay start button repeatedly, until the
lamp next to the required hours of delay is lit.
3. Press the button for the required programme.
4. After the set delayed start time has elapsed,
the programme starts.
Changing the delayed start:
If the programme has not started, you are still able
to change the set time with the delay start button.
Cancelling the delayed start:
If the programme has not started, the delayed
start can be cancelled. Press the delay start
button repeatedly, until none of the lamps next
to the hours are lit. The required programme
starts immediately.
A