Filter
Top Products
12 electrolux first use
The water softener must be set in
both ways: manually, using the water
hardness dial and electronically, using
some of the programme buttons on
the control panel
Setting electronically
The dishwasher is factory set at
level 5.
1. Press the On/Off button. The
dishwasher must be in setting
mode.
2. Simultaneously press and hold
buttons 2 and 3, until the lights of
buttons 1, 2 and 3 start flashing.
Setting manually
The dishwasher is factory set at
position 2.
1. Open the dishwasher door.
2. Remove the lower basket from the
dishwasher.
3. Turn the water hardness dial to
position 1 or 2 (see table).
4. Replace the lower basket.
3. Press button 1, the lights of buttons
2 and 3 turn off while the light of the
button 1 goes on flashing, at the
same time the end of programme
indicator light starts to flash, along
with a sequence of intermittent
audible signals.
The current level is indicated by the
number of flashes of the end of
programme indicator light together
with a sequence of intermittent
audible signals and a pause of a
few seconds.
Examples:
5 flashes / 5 intermittent audible
signals, pause, 5 flashes / 5
intermittent audible signals, pause,
etc... = level 5
6 flashes / 6 intermittent audible
signals, pause, 6 flashes / 6
intermittent audible signals, pause,
etc... = level 6
4. To change the level, press button 1.
Each time the button is pressed the
level changes. (For the selection of
the new level see the chart).
Examples:
if the current level is 5, by pressing
button 1 once, level 6 is selected.
if the current level is 10, by
pressing button 1 once, level 1 is
selected.
5. To memorise the operation, switch
off the dishwasher by pressing the
On/Off button.
117985 59/0en 16-05-2007 14:37 Pagina 12