Filter
Top Products
26
What to do if...
Remedying small malfunc-
tions
If the acoustic signal is activated, warning tones
sound if there are faults.
If one of the following fault codes is displayed in the
multi-display during operation:
– Fault codeÅ10 (Problems with water inlet),
– Fault codeÅ20 (Problems with water drainage),
please have a look at the following table.
When the fault is remedied, press the button for the
cycle that has started. The cycle will continue.
With other fault codes (“Å ” followed by a number):
– Abort the dishwashing cycle.
– Switch the appliance off and on again.
– Re-set the dishwashing cycle.
If the fault is displayed again, please contact your lo-
cal Service Force Centre and inform them of the fault
code.
Malfunction Possible cause Remedy
1 short warning tone, continu-
ously repeated, can be heard,
the cycle indicator for the selected
wash program is flashing:
the control indicator lights
up:
fault code Å10 is displayed in the
multi-display:
(Problems with water inlet)
Water tap is blocked with limescale
or is faulty.
Check the tap and have it repaired, if
necessary.
The tap is turned off. Turn on the tap.
The filter (where present) in the
threaded hose fitting on the tap is
blocked.
Clean the filter in the threaded hose
fitting.
Filters in the base of the washing
compartment are blocked.
Cancel the dishwashing cycle (see
chapter: Starting a dishwashing cy-
cle),
clean filters (see chapter: Cleaning
the filters),
then start the dishwashing cycle
again.
Water supply hose has not been
correctly positioned.
Check the position of the hose.
2 short warning tones, continu-
ously repeated, can be heard,
the cycle indicator for the selected
dishwashing cycle is flashing,
fault code Å20 is displayed in the
multi-display. (Problems with wa-
ter outflow)
The sink outlet is blocked. Clean the siphon.
Water drain hose has not been cor-
rectly positioned.
Check the position of the hose.
3 short warning tones, continu-
ously repeated, can be heard,
Fault code Å30 is displayed in
the multi-display.
The anti-flood system has been
triggered.
First shut off the water tap, then
switch off the appliance and contact
the Customer Care Department.