Filter
Top Products
electrolux
13
Attention!
During the stability period by the first
starting the temperature displayed can
not correspond to the setting
temperature. During this time it is
possible that the temperature
displayed is different than the setting
temperature.
Attention!
Difference between the temperature
displayed and temperature setting is
normal. Especially when:
• a new setting has recently been
selected
• the door has been left open for a
long time
• warm food has been placed in the
compartment
Difference until 5°C inside the
compartment are quite normal.
During normal functioning the indicator
shows the warmest temperature inside
the compartment.
Storage of frozen food
When first starting-up or after a period
out of use, before putting the products
in the compartment let the appliance
run at least 12 hours. To obtain the
best performance from this appliance,
you should:
if large quantities of food are to be
stored, remove all drawers and
baskets from appliance and place food
on cooling shelves.
Pay careful attention not to exceed load
limit stated on the side of the upper
section (where applicable) .
Important
In tthe eevent oof aaccidental ddefrosting,
for eexample ddue tto aa ppower ffailure, iif
the ppower hhas bbeen ooff ffor llonger tthat
the vvalue sshown iin tthe ttechnical
characteristics cchart uunder ""rising
time", tthe ddefrosted ffood mmust bbe
consumed qquickly oor ccooked
immediately aand tthen rrefrozen ((after
cooling).
Excessive temperature
alarm
An increase in the temperature in a
compartment (for example due to an
power failure)
is indicated by:
• flashing temperature;
• flashing of the icon ;
• sounding of buzzer.
When normal conditions are restored:
• the acoustic signal shuts off;
• the temperature value continues to
flash;
When you press key "E" to de-activate
the alarm, the highest temperature
reached in the compartment appears
on indicator for some seconds.
Then it returns on the normal operation
showing the temperature of the
selected compartment.
During the alarm phase, the buzzer
can be switched off by pressing key E.