Filter
Top Products
11
Electrolux 818 38 03-01/7
Something Not Working
GB
Before contacting your local Service Force Centre check the following point:
Problem Possible cause / Remedy
"" is displayed in the temperature
display.
Please contact your local Electrolux Service Force Centre
Audible alarm + flashing red warning
lamp. (It is too warm inside the freezer.)
Switch off the audible alarm by pressing the alarm off button.
The audible alarm could have been triggered by:
The cabinet having been recently switched on and the
temperature still being too high. See the chapter "Switching on
and setting the temperature".
The door may have been open for so long that the `door open'
alarm was triggered.
It is too warm inside the freezer. Set a lower temperature.
Make sure that the door is completely closed and that the
insulating strip is complete and clean.
If warm food products have been put inside the freezer, wait for
a couple of hours and then check the temperature again.
Distribute the food products to allow cold air to circulate
around them.
It is too cold inside the freezer. Set a warmer temperature.
Fast Freeze could have been switched on.
The temperature display shows the highest temperature inside
the cabinet. Thus a difference between the temperature
indicated on the display and the (average) temperature
measured in another way is normal.
Too much frost and ice are produced. Make sure that the door is completely closed and that the
insulating strip is complete and clean.
The compressor operates continuously. Set a warmer temperature.
Make sure that the door is completely closed and that the
insulating strip is complete and clean.
The temperature where the cabinet is placed is above normal
room temperature.
No ice The ice machine is not switched on. Start the ice machine. See
the section "Switching the i ce machine on and off".
No water supply. Carry out the necessary measures on the
water supply.
The ice dispenser lamp flashes Leakage at the water connection. Remedy the leakage and
empty the box by pulling out the red plug.
See the illustration i n "Connecting t he water hose".
Storage temperature too high. Lower the temperature in the
refrigerator.
The ice dispenser lamp flashes and no ice
comes out.
No water supply. Carry out the necessary measures on the
water supply.
Re-set the system by pressing the button (I).