Filter
Top Products
14
Electrolux 818 38 03-01/7
Door Reversal
It is not possible t o re-hang the door.
Connecting the water hose.
The water coupling is connected to a water
tap with an external 3/4 inch thread.
This work is to be carried out by a skilled
plumbing installation technician.
The refrigerator is to be connected with a
shut-off cock. There are different type-approved
taps and tap assemblies on the market.
The water hose must not be cracked, squeezed
or be in tight bends.
If you require a longer water hose than that supplied,
then a VDE-approved 150 38 85-02/0 supply hose
should be used.
Before the refrigerator is taken into use in its final
location, ensure that the water connection has been
correctly carried out, that there is no leakage at the
connection to the refrigerator water valve or to the
water tap, and that the four spacers are properly in
position, see the illustration.
We recommend that the refrigerator is placed on a
"run-off" mat intended for refrigerators and freezers,
which makes it easier to detect possible leakage.
When the w ater system is started
for the first time.
The following should be carried out when the
refrigerator is correctly connected to the water
supply in the building:
Open the tap on the water connection and start up
the refrigerator. The ice machine starts automatically.
It will start filling with water will start when the
temperature is sufficiently low. Do not use ice
produced during the first day since there is risk of a
slight taste.
Electrical cord
Do not remove the power cord by pulling on its
lead, particulary when the pr oduct is being
pulled out of its niche.
· Damage to the cord m ay cause a short-circuit, fire
and/or electric shock.
· In the event of damage to the appliance's main
cable, only an authorised service company
recommended by the manufacturer or a similarly
qualified person may adjust it in order to avoid
shock hazard for the user.