Filter
Top Products
11
Setting the amount of rinse aid required
3 Only change the amount dispensed, if smears, milky spots (reduce the
amount) or dried on water spots (increase the amount) can be seen on
glasses and dishes. (See section “If dishwashing results are not satisfac-
tory”.) The dosage can be set from 1-6. The dosage is pre-set to “4” in
the factory.
1.Open the dishwasher door.
2.Press the release button on the rinse
aid compartment.
3.Open the cover.
4.Set the dosage level.
5.Press the lid shut until it clicks into
place.
6.If rinse aid has leaked out, wipe it
away with a cloth.
Activating/deactivating the inflow of rinse aid
1.Press the ON/OFF button.
3 If the only LED indicator illuminated is one that belongs to a pro-
gramme button, this means that this dishwashing cycle has been acti-
vated. The dishwashing cycle must be deselected:
Press function buttons 2 and 3 simultaneously for approx. 2 seconds.
The LED indicators of all the buttons that can be selected light up.
2.Press function buttons 2 and 3 simultaneously and keep them pressed.
The LED indicators for function buttons 1 to 3 will flash.
3.Press function button 2.
The LED indicator for function button 2 will flash.
The multi-display will indicate the current setting:
4.Pressing function button 2 activates and deactivates the rinse aid dis-
pensing function.
5.Once the multi-display is indicating the required setting, press the ON/
OFF button. The setting is now saved.
0d Inflow of rinse aid is deactivated
1d Inflow of rinse aid is activated (factory setting)