Filter
Top Products
Fault code and malfunction Possible cause and solution
• continuous flashing of the light of the run-
ning programme
• point-shaped optical signal is flashing
•
appears in the digital display.
• intermitted audible signal
Anti-flood device is activated.
• Close the water tap and contact your local
Service Force Centre.
The programme does not start. • The dishwasher’s door has not been properly
closed. Close the door.
• The main plug is not plugged in. Insert the
main plug.
• The fuse has blown out in the household fuse
box.
Replace the fuse.
• Delay start has been set.
If dishes are to be washed immediately, cancel
the delay start.
The flashing of the point-shaped optical signal on the floor beneath the dishwsher's
door will not be visible if the appliance has been installed higher up with a furniture
door mounted flush.
Once these checks have been carried out, switch on the appliance: the programme
will continue from the point at which it was interrupted.
If the malfunction or fault code reappears contact the Service Force Centre.
For other fault codes not described in the above chart, please contact your local
Service Force Centre, quoting the model (Mod.), product number (PNC) and serial
number (S.N.).
This information can be found on the rating plate located on the side of the
dishwasher door.
So that you always have these numbers at hand, we recommend you to make a
note of them here:
Mod. : . . . . . . . . . . . . . . . . . . . . . . .
PNC :. . . . . . . . . . . . . . . . . . . . . . . .
S.N. : . . . . . . . . . . . . . . . . . . . . . . . .
What to do if…
31