Filter
Top Products
The wash results are not satisfactory
The dishes are not clean • The wrong washing programme has been se-
lected.
• The dishes are arranged in such a way as to
stop water reaching all parts of the surface.
The baskets must not be overloaded.
• The spray arms do not rotate freely due to
incorrect arrangement of the load.
• The filters in the base of the washing com-
partment are dirty or incorrectly positioned.
• Too little or no detergent has been used.
• Where there are limescales deposits on the
dishes; the salt container is empty or the in-
correct level of the water softener has been
set.
• The drain hose connection is not correct.
• The salt container cap is not properly closed.
The dishes are wet and dull • Rinse aid was not used.
• The rinse aid dispenser is empty.
There are streaks, milky spots or a bluish coating
on glasses and dishes
• Decrease rinse aid dosing.
Water drops have dries onto glasses and dishes • Increase rinse aid dosing.
• The detergent may be the cause. Contact the
detergent manufacturer’s consumer care line.
If after all these checks, the problem persists, contact your local Service Force Cen-
tre.
Technical data
Dimension Width - height - depth (cm) 59,6 x 86,8-94,8 x 55,5
Electrical connection - Voltage
- Overall power - Fuse
Information on the electrical connection is given on the rating
plate on the inner edge of the dishwasher's door
Water supply pressure Minimum
Maximum
0,05 Mpa (0,5 bar)
0,8 Mpa (8 bar)
Capacity Place settings 12
32
Technical data