Filter
Top Products
Operating Instructions
16
Adjusting Rinse Aid Dosing
3
As the dishes are washed rinse aid is released from the dispenser into
the wash water. The dose is factory set at 4, and can be adjusted from
1 to 6. Only change the setting if streaks, milky spots or dried on water
marks are visible on glasses or crockery.
0 1. Open the door of the dishwasher.
2. Press the rinse aid compartment
release button with your finger.
3. Fully open the rinse aid compartment
lid.
4. Set the dose level.
5. Close the lid and press until it locks
into place.
6. If rinse aid has run out, wipe up with
a cloth.
Switching the Acoustic Signal for the End of the Wash
Programme On and Off
In addition to the visual indication the dishwasher can be set to emit
an audible signal at the end of a wash cycle.
0 1. The dishwasher must be switched off.
2. Simultaneously press and hold down function buttons 1 and 2.
3. Press the ON/OFF button. The LED displays for the engaged function
buttons will flash.
4. Press function button 1.
The multidisplay shows the current setting:
5. Pressing function button 1 changes the setting.
6. Once the multidisplay shows the required setting, press the ON/OFF
button. The setting is then saved.
b0
Acoustic signal switched off
b1
Acoustic signal switched on (factory setting)