Filter
Top Products
Operating Instructions
31
What to do, if ...
Try to rectify minor faults on the dishwasher with the aid of the
instructions given here. If you call an engineer to resolve a of fault
listed here, or to repair a fault caused by incorrect use or installation, a
charge will be made even if the appliance is in guarantee.
...Error messages
• If the multi-display indicates the fault code (2, or the WATER,
DOOR or SPRAY ARM indicator illuminates, you can probably rec-
tify the fault yourself. After rectifying a (2 fault or a fault related to
the WATER indicator, press the button for the wash programme that
has been started. The wash programme should continue. If the fault
code is displayed again, contact AEG Service Force.
• For all other faults that are indicated, please contact AEG Service
Force stating the fault code.
Symptom Possible Cause Solution
The programme indicator for
the programme selected is
flashing, the WATER indica-
tor is illuminated and
1 warning tone can be
heard that is continually
repeated: no water is run-
ning into the dishwasher.
Tap is blocked or furred
with lime-scale.
Clean tap.
The filter (where present)
in the threaded hose fit-
ting is blocked.
Clean the filter in the
threaded hose fitting.
The water inlet hose
is not correctly laid.
Check hose
installation.
The programme indicator for
the selected programme is
flashing, the multi-display is
indicating the fault code (2
and 2 warning tones can be
heard that are continually
repeated.
The sink outlet is
blocked.
Clean the sink outlet.
The water drain hose
is not correctly laid.
Check hose
installation.
The multi-display is indicat-
ing the fault code (3 and
3 warning tones can be
heard that are continually
repeated.
The anti-flood system
has been triggered.
Close the tap and contact
your local AEG Sevice Force
Centre.