Filter
Top Products
13
Setting electronically:
1.Press the ON/OFF button.
3 If the name of a stage of a cycle is shown on the display, this means a
programme is active. You must first of all cancel the programme:
– Press the RESET key combination.
The display will read CONFIRM CANCEL?
– Press the OK/START button. This will cancel the rinsing cycle.
2.Go to the WATER HARDNESS setting; see section “Adapting an option/
setting”.
3.Set WATER HARDNESS to the right setting.
If the water softener is set electronically to “1” this switches off the
display of the REFILL SALT message.
Water hardness Adjusting the hardness setting
in °d
1)
)
1)(°d) German degree, measure of the hardness of water
in mmol/l
2)
)
2)[mmol/l] millimol per litre, international unit for water hardness
Range Manual Electronic
51 - 70
43 - 50
37 - 42
29 - 36
23 - 28
9,0 - 12,5
7,6 - 8,9
6,5 - 7,5
5,1 - 6,4
4,0 - 5,0
IV 1
10
3)
9
8
7
6
3)On this setting the length of the dishwashing cycle may be slightly longer.
*) factory setting
0*
19 - 22
15 - 18
3,3 - 3,9
2,6 - 3,2
III
5
4*
11 - 14 1,9 - 2,5 II 3
4 - 10 0,7 - 1,8 I/II 2
below 4 below 0.7 I
1
no salt necessary