Filter
Top Products
27
Starting a dishwashing cycle
1.Check that the spray arms can turn freely.
2.Turn the water tap on fully.
3.Press the ON/OFF button.
4.Use the direction buttons ( or ) to select the cycle required.
The name of the selected rinsing cycle will flash. The predicted duration
of the cycle is displayed to the right of the cycle name.
5.Press the OK/START button.
6.Close the door. The dishwashing cycle will begin.
A light signal in the form of a dot appears at floor level.
3 If the dishwasher is built in at high level with flush fitting cupboard
doors, the light signal cannot be seen.
The dot shaped light signal is not dangerous. (It is not a laser.) It lights
up while a dishwasher cycle is running and goes out when the cycle
ends.
In the text display you will see the name of the current stage of the cy-
cle. Beside this you will see the predicted time remaining in minutes.
The OPTION button allows you to briefly view the name of the rinsing
cycle in the display.
3 A rinsing cycle can only be started from the cycle menu.
3 During the rinsing cycle, the remaining time shown on the display is
adjusted according to the size of the load, degree of soiling, etc.
3 You cannot make changes to the options or settings while a rinsing cy-
cle is in progress.
Interrupting or Cancelling a dishwashing cycle
Interrupt a dishwashing cycle that is in progress if it is absolutely nec-
essary.
3)When using this cycle, only load the dishwasher half full.
4)During the final rinse, the temperature is increased to 68° for 10 minutes to give a greater
degree of hygiene e.g. plastic chopping boards or jam jars.
5)Test programme for Test Institutes
6)This cycle does not need any detergent.