Filter
Top Products
7
2. INSTALLATION
LOCATION C (fig. 6)
Check that the outgoing electrical connections from
the terminal strip are tight.
3.
Refit side cover of the compressor compartment into
position refixing the screws holding the side cover
(fig. 7)
4.
INSTALL firmly the appliance on a level floor,
preferably on wooden blocks or on a wooden platform
to protect it from damp and dirt. (fig. 8)
Leave sufficient space on all sides
of the appliance, keep it away from
the walls for good circulation of air
around it, see below:
Back and left side should be
minimum 3 cm away from the walls
(fig. 8a)
Hinges can be pushed against the
wall.
Right side should be minimum 10
cm away from the wall (fig. 8b)
5.
The appliance has 4 supporting
legs. If the appliance is not in a
level and stable position, adjust this
by adding wooden blocks or similar
under the legs.
Fig 6.
Fig 7.
Fig 8.
Fig 8b.
Fig 8a.