Filter
Top Products
75
Installation - Fig. 7-8-9-10
Assembling the deflector (3 parts only for filter version):
The three parts should be fixed with 2 screws, the deflector
extension is adjustable and should correspond to the width
of the chimney flue support, to which it is then fixed. Fig. 7.
Expansion plugs are provided to secure the hood to most
types of ceilings. However, a qualified technician must verify
suitability of the materials in accordance with the type of
ceiling. The ceiling must be strong enough to take the
weight of the hood.
During electrical connection ensure the power supply is
disconnected at the domestic mains switch.
Adjust extension of the hood support structure, as the
final height of the hood depends on this, and remember
that with installation completed the hood must be at least
50 cm above the hob top for electric cookers and 65 cm
for gas or mixed fuel cookers.
Fix the two sections of the structure using 8 screws (2).
Place the ceiling hole diagram directly above the hob
top (3 - the centre of the diagram must match the centre
of the hob top and the edges must be parallel to the
sides of the hob top the side of the diagram with the
wording FRONT corresponds to the control panel side). Prepare the electrical
connection.
Drill as shown (6 holes for 6 wall plugs 4 plugs for fixture), screw the outer screws
leaving a space of about 1 cm. between the screw head and the ceiling (4).
Fit an exhaust pipe inside the support (5) and connect it to the motor compartment
connection ring (exhaust pipe and fixing brackets are not supplied).
Hook the frame onto the 4 screws (6 - see also step 4).
CAUTION! The side of the support with connection box corresponds to the side of the
control panel with hood assembled.
Tighten the 4 screws (7).
Insert and tighten another 2 screws in the remaining free holes (8) for secure fixing.
Carry out the electrical connection (9) to the mains power supply, only turn on the
power supply upon completion of assembly.
Hook the hood onto the support (10) , ensuring it fits properly to hook the hood onto
the support partially tighten 4 screws (see also step 12).
Secure the hood to the support using 6 screws (11); this will also help centre the two
sections.
Tighten the 4 screws securing the support to the hood (12).
Fig. 7