Filter
Top Products
11
2.7. BASKET LIFTING (fig.4 - only for models supplied with
automatic lifting system)
• Press push buttons “D” to lift supports “I”, positioning the baskets
with the food to be cooked on the runners.
• Set the cooking time like suitable in the paragraph 2.6
• Press push buttons “D” and the supports will lower introducing
into the basin the baskets starting the cooking cycle. At the end
of the cycle, the supports will be lifted together with the baskets.
• To repeat the same cycle, just press push buttons “D”. The timer
does not have to be reset.
2.8. LUMINOUS PUSH BUTTONS (fig. 5 - only for models
supplied without automatic lifting system)
The luminous push buttons "D" keep on with green light while the
cooking cycles lasts; when the cooking cycle is over push buttons
"D" go off and the red lamp "Z" starts flashing.
2.9. PROCEDURES TO BE CARRIED OUT AT THE END OF
WORKING DAY
• Make sure the heating elements are switched off and turn off
the power supply.
• Drain the water from the basin by opening on the drainage tap
"R" fig. 3 (lever positioned vertically).
• Clean the basin and baskets of any food residue.
• Switch off the power at the mains and close the water cut-off cock.
3.0. SAFETY DEVICE (fig.3)
• Fuse replacement: The fuse protecting the electrical compo-
nents can be found by the terminal block. To replace it, lift up the
fuse holder and slide it out.
This operation must be carried out by a specialised technician.
3. CLEANING AND SERVICING
Before carrying out any maintenance operations make sure
that the power supply is switched off at the mains.
• Clean the stainless steel surfaces daily with warm water and a
neutral soap; rinse thoroughly and dry carefully.
• Water must not be left in the basin when the appliance is not
being used because the normal passivation of the steel would be
hindered making its surfaces less resistant to the corrosive affects
of salt.
• Periodically check that the overflow pipe "E" (fig.4) is clean,
remove any eventual deposits caused by the froth generated
while cooking.
• Never use sharp implements when cleaning the rubber pipes.
• When cleaning the stainless steel surfaces never use aggressi-
ve detergents, common wire wool, wire brushes or other such
implements as ferrous particles can deposit on the stainless steel
surfaces causing rust spots due to their oxidation. Stainless steel
wool can be used, but remember to rub in the direction of the
stainless steel satin finish.
• If the appliance is not to be used for a long period, then these
instructions must be followed:
- apply a protective film of Vaseline oil on the stainless steel
surfaces using a damp cloth and make sure that the premises is
aired regularly.
Caution:
• Do not wash the appliance with water jets.
• For the cleaning of the appliance do not use products containing
chlorine, bleach, chloric acid etc. even if diluted.
• Do not use corrosive substances such as hydrochloric acid
when cleaning the pavement surrounding the appliance.
• When scrapping the appliance, onbserve all regulations
governing waste displosal in the country of installation.
• Our appliances are manufactured using more than 90 % metal
(stainless steel, iron, aluminium, galvanaised sheet metal) and
therefore these may be recycled in conventioanl waste recovery
sites in compliance with current standards in the country of
installation.
• Render the appliance completely inoperative by removing the
power cable and any other closure device (where fitted) to avoid
the risk of children being trapped inside.
• When scrapping the appliance, onbserve all regulations
governing waste displosal in the country of installation.
• Our appliances are manufactured using more than 90 % metal
(stainless steel, iron, aluminium, galvanaised sheet metal) and
therefore these may be recycled in conventioanl waste recovery
sites in compliance with current standards in the country of
installation.
• Render the appliance completely inoperative by removing the
power cable and any other closure device (where fitted) to avoid
the risk of children being trapped inside.
Suggestions
It is advisable to periodically check the appliance (at least once a
year). To this end we advise you to obtain a maintenance
contract.
The manufacturer accepts no liability for situations arising
from failure to comply with these indications.
5