Electrolux RH36WC60GS Ventilation Hood User Manual


 
20
Clear and Cleaning
Optional Charcoal Filters
If the model is not vented to the outside, the air will be recirculated through disposable charcoal lters that
help remove smoke and odors.
The charcoal lters cannot be cleaned.
They must be replaced.
The charcoal lters are clipped inside of each metal grease lter (mounting instructions included with charcoal
lters kit).
The charcoal lters should be replaced every 4-6 months (depending on hood usage).
NOTE: DO NOT rinse, or put charcoal lters in an automatic dishwasher.
NOTE: Charcoal lters are not included with the hood.
They must be ordered from your supplier.
Order the needed kit specifying your hood model and width size.
Char coal lter placement (Recirculating accessories)
Fit the charcoal lter mattress on the upper side of each grease lter.
Use provided springs to x it in place.
Note: When removing for replacing for a new one do not remove Fixing Springs, simply pull out and rotate
outwards.
Cleaning
Always use the mildest cleaner that will do the
job. Use clean, soft cloths, sponges or paper
towels.
Rub stainless steel nishes in the direction of the
grain. Wipe area dry to avoid water marks.
After cleaning, place all parts in their proper
positions before using.
The cleaners recommended below indicate a type
and do not constitute an endorsement. Use all
products according to package directions.
Hood Surface
Painted Surfaces: For general care, wipe the outside
of the hood with sudsy water or household cleaners
such as Fantastic
®
or Formula 409
®
, rinse well and dry
with a clean soft cloth to avoid water marks.
Stainless Steel Surfaces: Wipe and dry stainless
steel in the same direction as the grain. Avoid using
too much pressure, which may mar the surface. To
remove nger prints and give added shine, use
cleaners such as Stainless Steel Magic. Do not allow
any cleaning compounds to remain in contact with
stainless steel for extended periods.
Plastic surfaces: Wipe with a moist soapy sponge.
Rinse and dry.
Aluminum Mesh Filters: Clean lters in the dish-
washer or by agitating in sudsy water. Ensure that
there is no soil trapped in the ne mesh. Dry the
lters before reinstalling them.
Anodized Aluminum surfaces: Top cap is not remov-
able. Wash top and underside with hot sudsy water.
Rinse and wipe dry or apply Fantastic
®
or Formula
409
®
rst to a clean sponge or paper towel and
wipe clean. DO NOT USE powdered cleaners or
steel wool pads.
Fixing
Spring
Charcoal
Filter
Grease
Filter
To p
Side