Filter
Top Products
If the refrigerator is not cooling sufficiently, the
reason may be:
1. Inadequate ventilation of the cooling unit due to the
intake and/or exhaust air vents being partly or
completely blocked.
2. The evaporator is frosted up.
3. The thermostat setting is incorrect .
4. Gas pressure is incorrect - please check the pressure
regulator on the gas container.
5. The ambient temperature is too high.
6. Too much food is loaded at one time.
7. The door is not properly closed or the magnetic
sealing strip is defective.
If the refrigerator still does not work properly, call a
service technician.
WARNING! The sealed cooling system must not
be opened, since it contains corroding chemi-
cals under high pressure.
MAINTENANCE
Always turn to a qualified service technician who is
familiar with LP gas systems and refrigerator.
We recommend that a service technician check the
refrigerator once a year.
• Check all connections in the LP gas system for gas
leaks. Connections can be tested for leaks using a
soap solution. Do not use a naked flame! If there is
any suspicion of damage, call for a service technician.
• The ventilation openings are unobstructed.
• The Instruction Manual is available.
• Check that the burner is clean and free from combus-
tible material.
SOME USEFUL HINTS
Make sure that:
• The refrigerator is not operating on 12 V when the
vehicle is parked; otherwise you will drain the car
battery in a short time.
• Defrosting is carried out periodically
• The refrigerator is clean and dry with the door left
open when it is not to be used for some time.
• Liquids or items with a strong odour are well packed.
• The ventilation openings are unobstructed.
• The doors are secured by means of the both travel
catches when the caravan is on the move.
SERVICE AND SPARE PARTS
Service and spare parts are obtainable from your dealer
or Electrolux - consult the telephone directory.
INSTALLATION INSTRUCTIONS
REPOSITIONING THE HINGES
The refrigerator is equipped with reversible doors.
A special door reversing kit must be used to reverse the
doors.
For further information, contact your dealer or Electrolux.
DOOR PANEL
Door panels can easily be fitted or changed. The dimen-
sions of the panels must be:
Model RM 6501
Height upper door 265 ±1mm
lower door 833 ±1mm
Width 483 ±1mm
Thickness max. 4 mm
Before starting the mounting work, check that the panel
dimensions are in compliance with those given in the
table and the instructions are read thoroughly.
When mounting the panel, proceed as follows:
Upper door
• remove the two screws holding the control panel, pull
out the two knobs (energy selector and thermostat)
• unscrew the upper hinge pin and remove the door
• unscrew the upper part of the door frame, remove the
old panel
• insert the new panel and push the panel downwards
• fasten the upper part of the door frame with its three
screws
• please note that the panel must be changed on the
lower door, before the upper door can be mounted
lower door
• unscrew the middle hinge pin and remove the door
• unscrew the lower part of the door frame, remove the
panel stop (2x) and remove the old panel
• insert the new panel and push the panel upwards, put
the panel stop back in place and fasten the lower part
of the door frame with its three screws
• replace the lower door
• replace the upper door
• replace the control panel with its two screws and put
on the knobs.
14