Filter
Top Products
The flue gases are dispersed through the upper vent
grille or the roof vent together with the ventilation air.
The top, bottom and sides of the ventilation passage
should be insulated to prevent condensation and cold
draughts.
Ventilation heights
Minimum ventilation heights in mm.
Model Installation with
Upper side vent L205 Upper side vent L500 Roof vent R500
Lower side vent L500 Lower side vent L500 Lower side vent L500
RM 6501 1400 1400 1250
LP GAS CONNECTION
The refrigerator is designed for operation on LP gas, the
pressure of which must be 28 mbar for Butane and 37 mbar
for Propane. Check that this is stated on the data plate.
The refrigerator is not designed for operation on
town gas or natural gas.
CAUTION! CHECK THAT THE GAS SUPPLIED
TO THE REFRIGERATOR IS AT THE CORRECT
PRESSURE. SEE THE REDUCING VALVE ON
THE LP GAS CONTAINER.
The gas installation should only be carried out by a
person experienced in gas fitting. It is recommended that
the gas pipe feeding the refrigerator is so arranged that
it is possible to turn off the supply of the refrigerator.
VENTILATION OF THE UNIT
min. ventilation
height
min. 510
Condenser
20
40
385
60
FIG. 3a
Sealing gasket
e.g. of V-type
Batten
attached to
the floor
Sealing gasket
e.g. of V-type
This piece is
already on the
refrigerator
Cut out opening for the
side vent L500
is 341 x 451 mm
Floor
Cut out opening for the
side vent L500
is 341 x 451 mm.
L205 is 156 x 451 mm.
min. ventilation
height
min. 510
Condenser
FIG. 3b
Cut out opening for the
side vent L500
is 341 x 451 mm
Cut out opening for the
roof vent R500
is 87 x 507 mm
Door
20
FIG. 3c
Batten attached
to the side wall
Sealing gasket
e.g. of V-type
View from above
16