Filter
Top Products
17
Unusual noises.
The appliance is touching the
wall or other objects.
Appliance is not level.
A component, e.g. a pipe, on
the rear of the appliance is
touching another part of the
appliance or the wall.
The compressor starts after a
period of time.
See the "Cleaning and Care"
section.
This is normal, no error has
occurred.
The compressor does not start
immediately after changing
the temperature setting.
Water on the floor or on sto-
rage shelves.
Water drain hole is blocked.
If necessary, carefully bend
the component out of the
way.
Move the appliance slightly.
Readjust the feet.
Changing the light bulb
Warning! There is a risk of electric shocks! Before changing the light bulb,
switch off the appliance and unplug it, or pull the fuse or the circuit breaker.
Light bulb data: 220-240 V
1. To switch off the appliance, Unplug
the mains plug.
2. If it becomes necessary to replace the
lamp, prize out the lamp cover as
shown in the figure.
3. Change the defective light bulb with
one of the some power (the maxi-
mum power is shown on the light
diffuser).
4. Refit the light bulb cover.
5. Put the appliance back into opera-
tion.
Malfunction Possible Cause Remedy