Filter
Top Products
8
Control Panel of Freezer Compartment
A CB D
5
6
2
1
3
4
A. Pilot light (green)
B. Thermostat knob
C. Super control light (yellow)
D. Normal/Super push button
The control panel elements are: the thermostat (B) is also the on/off swit-
ch for the freezer compartment.
The green pilot light (A), which comes on when the mains voltage is avail-
ble. Switch the temperature regulator knob to a number position, the refri-
gerating unit automatically operates by system control. The yellow pilot
light (C) comes on when the normal/super push botton is pushed.
Important note: if you operate the fast-freeze switch or adjust the tempe-
rature regulator, it may happen that your appliance’s refrigeration motor
does not start immediately but only after some time. This does not mean
that your appliance has a fault.
Starting Up and Temperature Regulation of
Freezer Compartment
• Turn the temperature regulator (B) in the direction of “1”. The green
pilot light(A) comes on. The freezer motor starts up.
• Push the
Normal/Super push button (D), the yellow light (B) comes on;
Setting “0”: Off.
Setting “1”: Highest temperature, (warmest setting).
Setting “4” (end-stop) : Lowest temperature, (coldest setting).
The exact setting should be chosen keeping in mind that the temperature
inside the appliance depends on:
- the quantity of food stored
- how often the door is opened
- ambient temperature
21
Positioning
This appliance should only be installed at a location where the ambient
temperature corresponds to the climate classification indicated on the rat-
ing plate, which is located on the inside left of the appliance.
The following table shows which ambient temperature is correct for each
climate classification.
Climate classification for an ambient temperature of
SN +10 to +32 °C
N +16 to +32 °C
Your appliance needs air
For safety reasons, minimum ventila-
tion must be as shown Fig.
Attention: keep ventilation openings
clear of obstruction;
50 mm
min.
200 cm
2
200 cm
2
min.
D567
Reversing the door
The side the door opens can be changed from the right side (factory adjust-
ment) to the left side, if the installation site requires.
Warning! When changing the side the door opens, the appliance must not
be connected to the mains. Remove plug from the mains beforehand.
The appliance should be located in a dry atmosphere, out of direct sunlight
and away from continuous heat and extreme temperature, e.g. not next to
a boiler or radiator, or in a very cold room e.g. an outhouse. If these tem-
peratures are exceeded i.e. warmer or colder, then the appliance may not
operate correctly.
For building-in and door reversal instructions please refer to the relevant
instructions on the following pages.