Filter
Top Products
LOCATION OF APPLIANCE
This appliance must not be installed in a bed-sitting room of volume less than 20m³ or in a bathroom, shower
room or garage. It is essential that the appliance is positioned as stated below (see Fig. 1) i.e. shelves, wall
cabinets and cooker hoods must be fitted a minimum of 787mm directly above the top of hotplate and 400mm
above the hotplate when fitted in line with the outside of the appliance. If the units are intended to be fitted
adjacent to the appliance but less than 400mm above the hotplate, then a minimum space of 100mm must be
maintained between the sides of the unit and the appliance (see Fig.2). Curtains must not be fitted immediately
behind the appliance or within 150mm of the sides of the hotplate. If fitted next to or between two base units a
minimum space of 1mm must be left between each unit and the sides of the appliance. The hotplate must be
set to minimum of 7mm above the adjacent units. (Note: The levelling feet fitted to the appliance will achieve a
nominal height of 907mm -5+13mm). Base units not meeting the above conditions must be a minimum of
100mm away from the hotplate. L.P.G. cookers MUST NOT be installed below ground level, i.e in a
basement, or aboard any boat, yacht or other vessel.
Fig.1a All dimensions in mm Fig.1b
41
less
than
400
100
400
787
787